Baby swinging security gate

This is so the screws hold the pieces in front. I added a wheel on each end and a track in between with a wheel upside down on the floor to ride in the track. After all four screws are in place, check the frame that is is square. You have the chance to enter below by following the instructions on the widget! However, my opinions are entirely my own and I have not been paid to publish positive comments. Cut a back stile to length on the miter saw. Before assembling any of the pieces, shave off the factory edge for a more rustic look.

Now screw the stiles in place through the back stiles. See how to build a matching top half of the door for a full Dutch door here , build the Swedish Mora clock here , install the thin floor-to-ceiling board and batten here , and build the console table here. After all four screws are in place, check the frame that is is square. Cut the full cross brace to length. This keeps the bottom from sliding out and keeps the gate straight while rolling back and forth.